Monitor display settings

Configure the display settings of monitors connected to the appliance. After making changes, click Apply to save.

Note:
  • Monitor display settings are supported only on the local client of the BLAZE appliance.
  • The primary monitor is determined automatically based on which output port of the appliance is connected and cannot be changed by the user.

To configure monitor display settings

  1. Click Settings > Client settings.
  2. Click the Monitor tab.

Display mode

If two monitors are connected, select a display mode.

  • Duplicate: The same screen is shown on both monitors.
  • Extend: The two monitors act as a single wide display, with different content on each.
Note:
  • If a monitor is disconnected, the system automatically adjusts the settings to match the remaining monitor configuration.
  • In Extend mode, the Monitor and I/O settings window is displayed only on the primary monitor (monitor 1).

Resolution settings

Set the screen resolution for each monitor.

  • The resolution list shows only resolutions supported by the connected monitors.
  • Only resolutions larger than 1200×640 are shown.
  • In Duplicate mode, only resolutions supported by both monitors are listed.